MAX REPAIR 2, 250MLTo be Used as a Seperate Service with Max Repair 1 for Hair Bond Repair
Step 7 – After rinsing out MAX REPAIR 1, finger-dry the hair with a dryer, leaving 10-20% moisture in the hair before using the straightening iron. If too much moisture is left in the hair, the heat of the iron will generate steam. Ironing Temperature should be less that 180 C. Step 8 – Comb and section hair .Starting at the nape of the neck, take 1/8″ sections and Keep the iron at least 1/2″ to 3/4″ away from the scalp. Starting near the root area, treat 1/3 of the hair shaft, press, slide and repeat 2 times to a total of 2 seconds per location. Then go to the next section and repeat this through the hair ends. -Do not maintain the hot iron in one place for any length of time or hair breakage/burning may occur. A comb should be used to direct the hair exiting from the hot iron to prevent burning of the fingers. Since the hair near the scalp is more resistant than the ends, it may be necessary to straighten that area more. Some steaming may be noticed during the procedure. Continue this procedure up to the top of the head. – Avoid using clips for any length of time to pin the hair out of the way. Step 9- When Ironing is complete, gently comb hair as smooth and straight as possible with a wide-tooth comb and apply the MAX REPAIR 2 . Start at the nape and make 3/4″ partings across the section. Evenly saturate the hair from root to ends. Comb the hair with a wide-tooth comb while maintaining the hair in a straight configuration to distribute the cream evenly throughout the hair. Step 10 – Process for 5 minutes, then thoroughly rinse out the MAX REPAIR 2 for approximately 5 minutes. Step 11 – The hair is now ready. Do not shampoo hair for 48 hours.
Kehairtherapy is a cruelty free brand